Accell MPC-68K Series Manual de usuario descargar pdf (Pagina 37)

Special program

 The prompt returns to the FTMW when task 0 is ended using the END command. Then

you can execute the commands for an I/O and variable's value, checks.

 <Caution>

*The program currently being executed stops when you modify the program.

*You can't use Ctrl+A for program stop. Use Ctrl+] instead.

10 FORK 1 *JOB1

20 END /* the TASK0 is END

30 *JOB1

35 DO

40 ON 0

50 TIME 50

60 OFF 0

70 TIME 50

80 LOOP

#RUN /* program execute

# /* The prompt returns. TASK1 is running

TASK0 20 END /* Crtl+M display current running steps

TASK1 70 TIME 50

#PRINT SW(0) /* You can use the PRINT command for I/O check

# *0 [20] /* program stops by Ctrl+]

*1 [50]

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Sin comentarios

Accell MPC-68K Series Manual de usuario Pagina 37